3d 2004 not moving!

[Danfor]

I have 0 experience with PWC so maybe I'm asking a stupid question !! I just bought a 3d 2004. I put it in water. Start the motor, running fine but it's not MOVING. Like if it's in neutral ?! When I connect the key there is 2 beeps (normal) and a little after it's 3 beeps. Looking on BRP site I found the guide but there is nothing, no code, for 3 beeps. What's wrong ?

Thank you,

Dan

 

[D 5UPE]

Thats correct, theres nothing for 3 beeps. If its in the water running and going no place its probably over heating. So take the jet pump off and have it looked at. If your moving your cooling. Or should be. Not moving it'll overheat if the pump or shafts broke.

 

[ThreeD]

I belive the 3 beeps is a reminder that you have the key on the post and using up battery power while not running.

Run it on the trailer and look into the pump hole....check to see if the impeller is spinning when you turn it on and give it some gas. D 5upe is prly right, something is going on with the shaft or impeller