2006 GTI no beeps no start, but LCD display

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

Soogiedave

New Member
Please help folks.
2006 Seadoo GTI.
Ran on trailer in driveway a week ago.
Changed oil, filter, and plugs today. Also drained old gas and refilled with fresh.
At time of test run for operation, no beep and no start attempt when key placed on post, but LCD display lit up.
Both keys were tried.... same result.
Checked all fuses - all SAT.
Brand new battery installed - no change in results.
Please advise, and thanks ahead of time :)
 
No beeps at all means your beeper is not working which is a common failure.
Are you getting a slight click from the solenoid? Does it turn over when you jump the solenoid?
 
I was having the same issues as you are. Check down by the starter solenoid under the fuse box a couple of inches, You should see it there, on one side you will have a solid red wire running to the starter, the other side, is another red wire with two smaller red wires coming out. More than likely one of the small red wires has corroded and finally broke, just try attaching another red wire in their place. I attached a terminal end to mine and hooked to to the starter solenoid and ran in to a couple inches behind the solenoid, skinned the wire and attached the one I made. Problem solved.
 
Status
Not open for further replies.
Back
Top