Hi Everyone,
My son just purchased two 2004 rxp sea-doo, one has 25 hours and the other 29 hours.
I have done a lot of reading on here but I still have a few questions regarding the super charger.
I would like to put a set of Riva clutch washers in now and then rebuild it at 100 hours, no where in the manual or on line here does any one talk about reusing the needle bearings, I am wondering if you need the wax strip to hold them in place while installing the drive gear. I just don't see the point in buying a bunch of parts if not needed at 25 hours.
I am also wondering about the nut on the end of the shaft, should I replace it ?
what I was planning on doing was buying a couple sets of washers, the Riva holding tool, and the proper grease and changing them out, any advise would be greatly appreciated.
Thank You
My son just purchased two 2004 rxp sea-doo, one has 25 hours and the other 29 hours.
I have done a lot of reading on here but I still have a few questions regarding the super charger.
I would like to put a set of Riva clutch washers in now and then rebuild it at 100 hours, no where in the manual or on line here does any one talk about reusing the needle bearings, I am wondering if you need the wax strip to hold them in place while installing the drive gear. I just don't see the point in buying a bunch of parts if not needed at 25 hours.
I am also wondering about the nut on the end of the shaft, should I replace it ?
what I was planning on doing was buying a couple sets of washers, the Riva holding tool, and the proper grease and changing them out, any advise would be greatly appreciated.
Thank You