Last year i put in a new SBT engine in and rebuilt the carbs with genuine Mukini parts. Pop off set. It was broken in with extra oil in the gas. Seemed good and knew it was running rich during the break in.
low end runs great up to 4500 Rpm. Over 4500 rpm and above it will run for a few minutes and just cut out. It starts right up after it dies.
is this too rich or lean. Or something else?
thanks in advance
low end runs great up to 4500 Rpm. Over 4500 rpm and above it will run for a few minutes and just cut out. It starts right up after it dies.
is this too rich or lean. Or something else?
thanks in advance