• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2000 GTI (runs fine then only idles)

Status
Not open for further replies.

jarhead

New Member
I'm new here. Need some help. I have a 2000 GTI Seadoo. Just replaced the fuel baffle. The 4 lines are hooked up correct. The fule gauge stopped working and then the thing would run fine and then just bog down and only idle. After replacing the fuel baffle the fuel gauge works fine. I ran it four of five minutes at half throttle and all seemed fine then it just bogged down to an idle. ANY HELP?? Please.
 
clean the filter in the carb. sounds like when you had the hoses off you nocked some junk into the line and now the carb is not getting all the fule it wants.
 
clean the filter in the carb. sounds like when you had the hoses off you nocked some junk into the line and now the carb is not getting all the fule it wants.

The SEADOO was doing this before I took the lines off. I'll try the cleaning but as stated was acting up before I took the lines off. Thanks
 
I'm in the process new removing the carb because I had similar issues. I can't figure out how to take off the throttle/choke cables though. IT's frustrating!
 
Status
Not open for further replies.
Back
Top