• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1999 Seadoo GTX Limited - Good PSI?

Rob451988

New Member
bought this GTX 3-4 years ago. 951 motor. I believe I'm the 2nd owner. pervious owners were older and said they didn't beat up on it. As far as I know the engine has not been rebuilt or replaced. 293.8 hours on the info. are these good for compression? I saw 130-150 is new, also saw this motor is lower compression so 120 might be fine?

cylinder 1.jpgcylinder 2.jpg
 
300hrs means it needs a complete rebuild. Mine at 225hrs was needing a rebuild and is being rebuilt. The cyl had a ridge at the top, the end crankshaft seals were shot, the raves were leaking, the carbs needed rebuilding, and the pump need a bearing. So to keep running that you risk blowing the motor. Also 150-155 is new, 120 is low and needs rebuilt.
 
It idles just fine. It bogs down just a little bit when trying to plane but once it actually planes it runs great. 5000-5500 RPM about 30-35 mph. I try to keep it under that 5500 RPM mark because anything over 6K seems to blow the short exhaust hose/ connector between the exhaust manifold and the water box.

IMG_6873.jpeg
 
Back
Top