Briggerman1327 Member Oct 26, 2019 #1 I recently bought this jet ski. I noticed a crack in the hull close to where the drive shaft goes thru the hull. Has anyone seen this before? Any idea what caused it.
I recently bought this jet ski. I noticed a crack in the hull close to where the drive shaft goes thru the hull. Has anyone seen this before? Any idea what caused it.
mikidymac Moderator Staff member Moderator Oct 26, 2019 #2 Not common at all. Probably something like a rope and anchor got wrapped around the driveshaft. The correct fix would be to put a few layers of fiberglass on it with epoxy resin. The easy fix is some Marine-Tex epoxy.
Not common at all. Probably something like a rope and anchor got wrapped around the driveshaft. The correct fix would be to put a few layers of fiberglass on it with epoxy resin. The easy fix is some Marine-Tex epoxy.
Briggerman1327 Member Oct 28, 2019 #5 azsxr said: What does the intake tunnel look like? Click to expand... I didn’t see any damage, but it could be behind a black plastic mounding that the drive shaft runs through. I’m not sure how the mounding is attached.
azsxr said: What does the intake tunnel look like? Click to expand... I didn’t see any damage, but it could be behind a black plastic mounding that the drive shaft runs through. I’m not sure how the mounding is attached.
A alkiseadoo Member Nov 7, 2019 #6 West Marine 2 part epoxy works well and is easy to work with. Sand it well and apply it with fiberglass cloth tape 3x coats good to go.
West Marine 2 part epoxy works well and is easy to work with. Sand it well and apply it with fiberglass cloth tape 3x coats good to go.