1996 Seadoo Fuel Baffle Question

[SIMPLEARKANSAN]

I’ve replaced the filter cap, new float, pulled F1 fuse and soldered a bridge. I’ve hooked up my ohm meter and let the float slide back and forth but no change in readings. What else can I check?

 

[mikidymac]

That’s about it. Sounds like the actual board might be bad.

Did you actually check resistance across your solder bridge to make sure it made contact on both sides.

 

[SIMPLEARKANSAN]

Yes I checked continuity across the solder bridge. It was good. Guess maybe it’s the board.