Does it have a Mode button on the handlebar? If so push it 5 times in a row (while the check engine warning is scrolling across the dash)to get it to display the error code.
I believe your owner's manual will show you exactly where the fuses are, but in general they're near the battery on the left side of the hull with pop-off rubber covers over them.
- Michael
I found the fuses and the third one down on the front row was blown and it was 10 amp I replaced it with a 15 amp for a while and got the engine to turn over constantly. But I don't believe I am getting any fuel pump but I don't have any other blown fuses. Shouldn't I be able to hear the pump run? I tried the mode button 5 times then the set button but didn't get any codes. Thanks for the help
yes as soon as you attached the lanyard you should be able to hear the fuel pump kick on for about 3 seconds I believe (assuming they didn't change the MPEM layout from 03 to 04) the fuse that was blown was for the fuel pump/starter. That being said I must caution you about putting in a higher amp fuse then what it's suppose to have. Am guilty of doing it myself from time to time but there is a ton of electronics in these things and they can be very tempermental in our haste to see if it works we can end up causing more problems.
I would recommend disconnecting the connection at the fuel pump and see if you have power going to it at least to the connection and check for corrision why you have them apart and let us know if you have power to the connection.
Yep I'm aware of the bigger fuse syndrone. I haven't pulled the plug going to the top of the fuel pump yet but I suppose its going to be multiwire since I am sure it reads the fuel level from here also. After I figure out which wires are hot and which are grounds do you see any problem with putting 12v straight to the pump? I just can't believe these pumps go bad with just sitting (6 years). I have looked on the internet and found the part number for the fuel pump assembly 270600087 so does anyone know where you can buy them the cheapest for the assembly or can you just buy a pump from somebody else other than Seadoo? I really hate to spend the $6-700 for a pump assembly. Especially since I have two of these watercraft having the same problem. Oh I am going to the lake tomorrow so it will be 10-12 days before I am back and can look into it so feel free to fire in the suggestions. Thanks