fix

Hi guys! I just replaced my LCD on my 2004 Wake, when I plug the cluster back in it sits idle at 20 MPH and 3000 RPM, how can I "re-zero"/calibrate it back to sitting at zero where it should? Thanks in advance!

I overfilled my 2005 sea doo rxp with way too much oil and I took it out to the water it ran good for like 10 min then the oil light came on and the cluster said oil and it was in limp mode after that I took it home noticed I had overfilled it by a lot no water was in the oil I got the level to...

i have a 2001 Seadoo Speedster, and the ski pole will not luck when you turn it at its up position. it just rests there and when you put a little bit of pressure on the top it falls down. does anyone know how to get it to stay put? THANK YOU!!!

To day I ran a few more hours on my new Sea-Doo GTI SE 130. It now has 7 hours on it, I was not being rough with it, i am breaking it in very slowly and smoothly. But at the end of the day I removed the seat to find a black metal powder residue below the drive shaft , as well as a few small...

I had a bad mpem, it kept blowing the 5amp fuse, i attained a complete wiring diagram and can make it available, all that i need to convert the system was 2bombardier electric start key switches (solenoid position), 2 tether kill switches, 3 inline fuse blocks, ring wire connectors, female tab...

Hi there, So in 2003 i purchased a 2003 seadoo speedster. Over the years of storage from being away the boat has just sat until 2010. I was trying to look for an owners manual somewhere so I could do the check ups and make sure everything is running fine. I have put it on the water 6 times this...

i am taking my hood off of my 98 seadoo gsx to get painted i got it all off except for the info and the speedo guage how do you get them off i dont see no screws or anything does anyone know thanks