Hello. I have a ton of 1995 seadoo gtx parts for sale. I was going to fix the ski and then decided to just buy a new one. The hood, seat, knee pad, gas tank and mirrors are gone. The motor needs a top end rebuild. I bought new cylinder jugs and had them honed out. The pistons and rings need to...
I have my 95 gtx completely torn down to the cylinder jugs. My question is how hard is it to take the carbs off and clean them? I'm thinking while I am already that deep into the motor might as well take them off and clean them. I also got to change out the fuel lines. Still have the gray lines...
Finally got it free !!! After about a half of a can of pb blaster and a small butane torch plus a pair of long nose vice grips. Got it to free up. On with changing out the cylinder jugs and pistons. Thank you to everyone's insight on this!!
I just went a bought a can of pb blaster. letting it sit on there as we speak. The nut is pretty much rounded off. I have tried with a dremmel tool but the clearance for the cutoff wheel is to short. I attached a picture so you could see exactly what is going on with it. Im thinking some heat...
Im currently replacing the cylinder jugs and pistons/rings on my 1995 gtx. It has been going pretty smooth for me except for problem. Where the tuned pipe connects the exhaust manifold. I got 3 out of the 4 off no problem. There is one where the tuned pipe over hangs and its connected with a...
Hey sorry im just getting back to you on this. My mom was in the hospital so i didnt have much time for anything. By chance do you still have those cylinder jugs available
i checked the case out and the case appears to be fine. i thought for sure that i winterized it properly. I have been doing it myself for numerous years. made a mistake along the way this past winter somehow. thank you for the insight
Hey everyone. On my gtx, somehow someway, both cyliner jugs cracked. I had water flowing in like crazy when i fired it up this year. I tore it down and saw that the both jugs have cracks. I have been searching looking for new ones. Im not sure how to go about getting them. Just in case this is...
Thanks for the reply. i do not have a hose connection on the rear of the ski. Last year i took the pump off due to a bad drive shaft.While it was all apart i changed out the wear ring as well. the ski has a connection on the top of motor for a hose connect. Can i take off the flame arrestor to...