Recent content by robrat20

  1. robrat20

    97 xp fuel line help

    I pulled it off 2 bypass it still nothing, so might have a leak elsewhere?
  2. robrat20

    97 xp fuel line help

    I put a new motor in my xp changed all fuel lines rebuilt carbs and I'm trying to get it to run but it's not getting fuel the lines are clear so I can see that no fuel is building up I used a hand pump to pull fuel into the lines won't hold a prime any help would be appreciated
  3. robrat20

    Hi I was wanting to know if you have a set of carbs for a 1997 sea doo xp with the 787 Rob

    Hi I was wanting to know if you have a set of carbs for a 1997 sea doo xp with the 787 Rob
  4. robrat20

    1997 xp

    How do I get ahold of him on here not sure how this site works yet
  5. robrat20

    1997 xp

    Got the motor totally out today I'm getting a remain from Sea-Doo engine shop the carburetors are ****ed I need new ones. Anybody know where to get decently priced new carbs or used ones
  6. robrat20

    1997 xp

    Charleston
  7. robrat20

    1997 xp

    I bought a 97xp with trailer and cover and new battery for 425$ guy said front cylinder was frozen. Pulled motor found the piston was frozen and broke the bottom part off the piston and scored the cylinder wall. Everything else on ski works fine even the trim. I think I'm going to swap motors...
  8. robrat20

    Need RFI help

    Well it's running and hit 52mph today only thing wrong now is the steering is off and that black nut that goes over the steering rod on the outside to the hulll the threads to the nut have broke off in the hull so got 2 figure out how to fix that now
  9. robrat20

    Need RFI help

    Think I found the problem
  10. robrat20

    Need RFI help

    I did the install and had a company out of NY do the injectors. I have not tested the fuel pump pressure.
  11. robrat20

    Need RFI help

    Reman from SES
  12. robrat20

    Need RFI help

    I swap motors got a rebuilt motor from a sea doo shop so I got the motor and had it running a few days later. I'll check compression when I get home but when I was checking my plugs I turned it over without them in seen to have good flow coming out but I'll put the gauge on it
  13. robrat20

    Need RFI help

    I have new plugs in it and no warning lights,I lined up the marks on the oil pump so it should be good
  14. robrat20

    Need RFI help

    Got my new motor installed, Ran fine and idled fine took it for a water test ran great,ran it for about 5 min. Took it out later that day for a longer water test started right up but was running rough so took it out and went back home now it won't start just turns over if I give it a little...
  15. robrat20

    Low fuel gauge

    How much for one
Back
Top