seadoo gti 720 i was cranking engine didnt start and then locked
it now turns freely one revolution either way then locks
starter had been acting up for a while and i suspect it may be jammed
has anyone had similar problem and is it poss for starter to do this or is it wishfull thinking?
any...
yea your right im not gona spend owt on it if i cant sort it i will sell it on as spares repair
its just one i got cheap (now i know why) ha ha mite try cleaning carb see where that gets me
thanks for your input its much appreciated
it wont start even on drive unless i spray some fuel down pots
then it will run for a couple of seconds (would low compression stop the vacuum pump working on carb) or do you think it might need a clean out
i have a seadoo 720 gti with 110 compression on both pots
would this cause it not to start or is it poss i have another fault
its been stood about 18mth and i suspect carb may need cleaning but dont want to strip carb if its the compression to blame
if i spray some fuel in pots it will start...
i had it to dealers to program key but he dosnt seem to know whats wrong and couldnt program key
only got a few quid in it so may break it and keep parts for next project like you say nice to have some spare parts on hand cheers fred
i have a 2004 seadoo 3d rfi one long beep when attatch lanyard (so needs new key) when dealer went through process it would not work
tried new post same result also wont go into advanced diagnostics mode when you press stop/start 5 times nothing happens
checked all fuses all fine cant see...
hi i have a 98 seadoo gsx ltd it runs fine but has no beeps and no gauges
there is 0 volts coming from mpem (purple wire) i have got gauges working with switch connected via fuse to +ve
beeper works if connected to +ve
is there any other +ve lead that is only live when lanyard connected
or any...
hi got a 2006 seadoo gti se 4 tec when put dess lanyard on i get no beeps but gauges come on for about 2 or 3 secs then go out sometimes come back on if lanyard left on
will crank if overide solenoid checked and i have 12 volts on all 10amp fuses on ecu
ive checked all connections i can find...
hi bought a seadoo ski looks like been steam cleaned cos datatag numbers were half missing and the label from top off flywheel cover was missing
was concerned mite be a tad dodgy but ive contacted datatag and they say its fine they going to issue me numbers and reg. in my name. so alls well...
hi can anyone tell me if there is a second location for engine number on seadoo 720 as the label on top of flywheel cover is missing
presume it will be stamped some where on engine case but cant find it
cheers fred
i took lanyard apart and resoldered chip to plug (cant use it to ride ) but i now get 2 beeps and engine cranks so i defo need new lanyard
i only unpluged 2pin socket will unplug other one too just to be safe
hi i have a seadoo gsi 720 jetski had blown 5 amp fuse in rear box on replacing fuse got a cloud of smoke from vts box and fuse blew
i disconected box and get no beeps or anything when connecting lanyard
however if i use another lanyard i get one long beep (think this tells me lanyard is not...
spot on mate what i did was try the duff one on good ski and got nothing (so then tried good one on duff ski still got nothin till i fitted new mepm) so both dess posts i had tried and old mepm from duff ski were faulty its almost beyond beliefe but it now ok got 2 beeps but no spark (from...