I know that this has been posted before but I can't find the thread (which actually gave the solution to my problem).
None of my DESS keys were recognized by my machine - continuous "Readying Key". Disconnected battery and pulled all fuses and BUS bars from my fuse box and wire brushed the...
I'm sure a faulty computer can do a lot of things including shut things down but can't really say if that is your issue. I've seen four newer machines this year 'sunk' and non of them seem to have problems with electronics. Do note that the newer Sea Doo's are very fussy on a battery being good...
There is a TOPS switch that protects the engine (shuts it down) when flipped. I have seen this trigger (at least for one of mine) when machine is waterlogged as well.
NOTE - check your engine before you even attempt to turn it over -
- pull plugs - check plugs and cylinders for water before...
Sorry, it was the PTO end I was referring to. The rubber bumper was stuck in the PTO. Was able to fish it with needle nose.
Re that bearing pulling out - it had a bit of play so I think I'm just going to replace the whole pto bearing/seal assembly just in case.
Pulled my pump and shaft out today on my 2011 260 to replace carbon seal, sleave, pto bearing and seal.
Was surprised not to see a rubber bumper on the end (see pic). Shouldn't there be one there? Do I have to go fishing in the impeller housing for it?
Was also surprised that the pto bearing...