Will someone kindly rent me their engine alignment tool for $?

[elnook909]

I am in Houston but will setup shipping to and from your location for you and pay your fee.
Thanks!

 

[WaarrEagle]

I am in Houston but will setup shipping to and from your location for you and pay your fee.
Thanks!

Sent you a PM of a guy in NE Houston that had one in 2022.

 

[elnook909]

Sent you a PM of a guy in NE Houston that had one in 2022.

Thanks WaarrEagle,thanks for your info much appracited! I contacted so far no response.

 

[WaarrEagle]

The 2nd time i needed one I had success searching Facebook Marketplace. Then I resold it the same way when I was finished.

 

[Legacy37]

I made one using 1/2” conduit and a 3d printed sleeve I bought off ebay. Total cost was under 20 bucks

 

[Grim]

Legacy37, you got the 3d file for the sleeve, I'm interested in doing that as well

 

[mikidymac]

Legacy37, you got the 3d file for the sleeve, I'm interested in doing that as well

3D print and conduit are not going to be rigid enough or accurate enough but I guess it is better than nothing.

 

[Legacy37]

Legacy37, you got the 3d file for the sleeve, I'm interested in doing that as well

I don’t have the file, I bought it already printed off ebay. To be fair I used it to just verify alignment after swapping engines it has ran for a couple of years without drive issues.

 

[Legacy37]

Thread 'Inexpensive engine alignment tool- DIY'

Jun 30, 2015

This entire thing was hashed out in another thread. http://www.seadooforum.com/showthread.php?78643-Engine-alignmenet/page2

Since there is a spelling error in the title, and there are several branches in the thread, I decided to post a new clean one.

Using concepts from others, I designed a different way to align a two-stroke, single shaft motor, without having to rent or purchase a SBT tool.

DISCLAIMER- This tool has raised some controversy. I am convinced it is as good or better than the SBT tool. I have heard the SBT tool is really nice, but I have NEVER used one. So...

• soccerdad
• Replies: 59
• Forum: 2-Stroke Sea-Doo PWC Forum

• 

 

[elnook909]

Thanks all for your responses especially @WaarrEagle , the gentleman in Houston responded to my email and i was able to rent it from him and engine is aligned!
Thanks to this forum