• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Water coming out of hose connector after flushing

Status
Not open for further replies.
Hi I have a 2015 GTR 215. When I flush the engine quite a bit of water comes out of the hose connection. Haven't seen this happen to anybody else. Should I be worried?
 
Are you saying that once you complete the flush, meaning start the engine, start the hose, kill the hose, kill the engine, disconnect the hose that some water continues to spill out? Or is water shooting out the flush port while you are trying to flush?
 
I think you should shut the water off first, kill the engine, then disconnect the hose. I'm really not sure if that will make a difference, but that's the way my manual describes it. Some water comes out of mine doing it this way, but the way you describe it seems like more. Is some water coming out of your jet during flushing?
 
i would call this common unless the water is coming out with force, if it does come out with force there could be compression in the water jacket but take that with a grain of salt thats worst case scenario
 
Status
Not open for further replies.
Back
Top