Water bleed hose exit

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

pkh19

Active Member
Good morning All,

Hoping someone in your shop can answer a couple of questions:

1) The Water bleed hose connected to the exhaust manifold was pulled out and I can’t figure out where it attaches. See pic.
picture

picture


2) What is the clear plastic looking spout for on the cover; is this for spraying lubricant inside? See pic.
picture


Thanks for any help!

PH
 
Individual Pics.

Thanks!!
 

Attachments

  • Water Bleed Hose.jpg
    Water Bleed Hose.jpg
    87.3 KB · Views: 12
  • Water Bleed Hose Pic 2.jpg
    Water Bleed Hose Pic 2.jpg
    110.6 KB · Views: 12
  • Water Bleed Hose Pic 3.jpg
    Water Bleed Hose Pic 3.jpg
    83.6 KB · Views: 13
  • Plastic Spout or Port.jpg
    Plastic Spout or Port.jpg
    332.8 KB · Views: 13

Attachments

  • Water Bleed Hose.jpg
    Water Bleed Hose.jpg
    87.3 KB · Views: 4
  • Water Bleed Hose Pic 2.jpg
    Water Bleed Hose Pic 2.jpg
    110.6 KB · Views: 6
  • Water Bleed Hose Pic 3.jpg
    Water Bleed Hose Pic 3.jpg
    83.6 KB · Views: 5
  • Plastic Spout or Port.jpg
    Plastic Spout or Port.jpg
    332.8 KB · Views: 5
I'm not sure where the "pisser" hoses go overboard on the boats.

That little white barb on your airbox is for fogging the engine after you run it.

I suggest doing it after every run with your 951 engine. Just get a good fogging oil like Klotz, Stabil or Seadoo.
 
The two pissers exit at the center eye on the stern of my Sportster, both outlets are under a plastic bezel and directed down to flow over the rear swim deck. Keep your feet warm if you stand there and washes minor debris off the deck.
 
Status
Not open for further replies.
Back
Top