sam.straver
New Member
hello everyone I have a problem I do not measure any resistance on the fuel gauge with the magnet in it.
Now I saw on the internet that you have to make a hole in the gauge to get to the printed circuit board and then disconnect and bridge the F1, but I don't see any f1 at all, even though I'm in the same place as other people.
does anyone have any experience on how to make this thanks in advance?
Seadoo xp 1995 717 motor
Now I saw on the internet that you have to make a hole in the gauge to get to the printed circuit board and then disconnect and bridge the F1, but I don't see any f1 at all, even though I'm in the same place as other people.
does anyone have any experience on how to make this thanks in advance?
Seadoo xp 1995 717 motor
