Seadoo xp 1995 fuel gauge not working

[sam.straver]

hello everyone I have a problem I do not measure any resistance on the fuel gauge with the magnet in it.

Now I saw on the internet that you have to make a hole in the gauge to get to the printed circuit board and then disconnect and bridge the F1, but I don't see any f1 at all, even though I'm in the same place as other people.

does anyone have any experience on how to make this thanks in advance?

Seadoo xp 1995 717 motor

 

[JJinSC]

I have done this procedure a couple of times and that circuit board looks different. Check out this post. It seems similar.

No F1 fuse in fuel baffle

 

[sam.straver]

Thanks for your response, but I can't get any further with this because I measured my wires on the printed circuit board and they had good contact.

Could it be that my tank clock is broken?

When I start my jet ski, the lights are on, but I can't see the blocks for the fuel level.

Anyone have any ideas?

 

[JJinSC]

You should be able to check ohms with meter on the two wires coming out of the baffle. The ohms should change as you move the float up and down in the baffle. If that checks out then any issue would be in the wiring between baffle and gauge or the gauge itself.