• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

New Hydro Turf

Status
Not open for further replies.

TFWildman112

New Member
So I'm about to install new hydro turf, but my old mats have riviots going through them into to the hull. So how can i fill these holes cause I may never see them again after I put the new hydro turf down so I don't have a leak or devolope a leak?
 
I drilled all the rivets out and filled all the holes with silicone. Then your good to go for the hydroturf. Just rough up the area.
 
Will that work long term? I also live in massachusetts and winter storage is not inside lol. Also how did you fascin your hydro turf? Did you just use the gallon of contact cement you can buy?
 
Last edited by a moderator:
Ya it will work fine mine stay out too. Just pick up a 16 oz can of red label dap contact cement. It will b more than enough. Just sand the smooth part of seadoo and add cement to turf and to doo after 3 min slap together it ain't going no were lol.
 
Status
Not open for further replies.
Back
Top