Help, leftover part, where does it go?

[IDoSeaDoo]

Hey guys, I just finished putting a new timing chain and valves on my 4tec, and for the life of me can't figure out where the little rubber washer goes. It's small and grey, smaller than a dime, and it's flat, unlike an o-ring. I searched all the diagrams in the shop manual with no luck. The bottle cap is for size reference, please help.

 

[IDoSeaDoo]

Well, no replies from any of you and the other forums can't figure it out either... I guess it's not off the engine after all.

 

[ski-d00]

I don't think it is from a seadoo. No rubber washers like that anywhere in the engine I can think of.

 

[IDoSeaDoo]

:hurray: Glad to hear I don't have to rip it back apart. Also I have no left over parts or bolts so I feel really good about this build. It was my first 4tec build and I must say, THESE ARE A LOT MORE COMPLEX THAT THE 2-STROKES!