mgruenauer
New Member
just purchased 1996 sporster jet boat. first time jet boater.
good shape, need to replace the cockpit scupper ,,,
maybe keep my ankels dry.
runs great about 40 with one aboard.
question is : does anyone know where you can get the rubber molding used in the cockpit area between the sections of fiberglass. ours is white and shrunk quita bit ....looking at replacing.
also adding the accent padding to the floor and deck areas. any opinions on the floor pads?
our first issue was the rubber buttons on each end of the drive shaft which causes ventilation to occur and prohibits any kind of speed. just idles. new buttons , she goes great.
good shape, need to replace the cockpit scupper ,,,
maybe keep my ankels dry.
runs great about 40 with one aboard.
question is : does anyone know where you can get the rubber molding used in the cockpit area between the sections of fiberglass. ours is white and shrunk quita bit ....looking at replacing.
also adding the accent padding to the floor and deck areas. any opinions on the floor pads?
our first issue was the rubber buttons on each end of the drive shaft which causes ventilation to occur and prohibits any kind of speed. just idles. new buttons , she goes great.