hey guys having some sad luck with my seadoo, supercharger went, motor was taken apart, changed lots, motors all back together, seadoo got water in it(computer wasnt touched but engine had water in it) cleaned it out best as i could, but its throwing the codes p1520 and p0107, i was wondering if someone could lead me in the right direction of what to check, or what could cause this! thanks bleclair!
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
ENGINE CODES! p1520 and p0107!
- Thread starter bleclair
- Start date
- Status
mattydipps
New Member
1520 is oil pressure switch
0107 is map sensor shorted to ground.. could be a couple things.. sensor port dirty... sensor is bad..
0107 is map sensor shorted to ground.. could be a couple things.. sensor port dirty... sensor is bad..
should i just change oil pressure switch? and where is the sensor located for MAP
mattydipps
New Member
you could change the map sensor but i think it could be more of a wire connection then the actual sensor.. i would trouble shoot the wiring harness first..
and yes i would change the oil pressure switch... after i troubleshoot the harness... it sounds to me like even though you may not have seen water in the electrical that theyre still might be some condensation that caused a problem with your wiring harness.
- Status
Similar threads
