Carrier bearing tubing replacement

[Noahsfixingbrokedownskis]

Is there any specific tube that I can buy to replace the carrier bearing tube that is used in lieu of the carbon seal to seal the drive shaft. My 97.5 gray ghost had a carrier bearing and the tubing was torn up and bearing froze. I bought a new carrier bearing setup from osd but it didn't come with the tubing. Is there a certain type of tubing or hose I should buy and a set length? Also does I just tap the carrier bearing onto the driveshaft or is there a c clip like the carbon seal version that holds it in place?

 

[Spider4real]

You need part #292000075 (through hull fitting). You can find then at OSD and Amazon. Lots of videos to show how to install. Just epoxy it into place.

The driveshaft should just slide through the carrier bearing. No clips. The carrier bearing is clamped onto a rubber hose that in turn is clamped onto the through hull fitting

 

[tobytd]

I think he is asking for HOSE inside diameter and legnth.