Bailer pickup tubes & Engine water inlet removal

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

mshelton911

New Member
I am removing my jet pump to replace my wear ring on my 96' GTI. to remove the pump from the hull i need to remove the bailer pickup tubes and the water inlet tubes. With what, and how do I do this? THe pickup tubes look like they are stuck into the fiber glass. seems hard to remove ..yet i am new to seadoo mechanics so i might be making some mistakes. Has anyone else done this before? thanks
 
there should just be tie downs or clamps holding them in place on the pump you either cut the tie downs or loosen the clamps and then remove the pump
 
Status
Not open for further replies.
Back
Top