Ive recently purchased a seadoo gsi from someone here in town, i got it not running with a trailer for a very good price. all that it needed was a new mpem and key=). On my first outting i found that when you stab the gas it hits the limiter very fast, but it doesnt get out of the water as fast as its reving. my buddy has two gti's and he beats me out of the water, but we both do the same top speed. would this be an impeller, or wear ring, or both??
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
97 seadoo gsi questions.
- Thread starter surftouch
- Start date
- Status
ski-d00
Well-Known Member
backflushing is running it on the hose in your driveway. the drivetrain doesn't get sufficient cooling when doing this so you should only do it for a couple minutes at a time.
you won't get water in the hull, it suck air from the hull through the seal.
pull the pump first, it will probably be obvious what is bad if you're cavitating that badly.
you won't get water in the hull, it suck air from the hull through the seal.
pull the pump first, it will probably be obvious what is bad if you're cavitating that badly.
Last edited by a moderator:
- Status
