• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

96 GTX magnito plug

Status
Not open for further replies.

Black67tb

Member
Hello. I have a problem. Looking inside the magnito plug, l see only 5 prongs. I see 6 wires on the back. Is one broken off and missing? If there should be 6 prongs instead of 5, is there a way for me to repair the plug somehow? I would appreciate any feedback. Thanks.
IMG_20220316_121248.jpgIMG_20220316_120800.jpg
 
I'm pretty sure you have 3 yellow wires on top and a single yellow and single black wire on the bottom. The 3 yellow goto the Magnito and the single yellow/black goto the pick up coil. I think there is a light gray plug in that 6th hole.
 
I took a better picture of the back. As you can see, three top wires are yellow. But on the other side of THOSE, there are only 2 prongs. The other lower 3 wires, one black and one white go to the pick up. The other black, l suppose goes to the stator plate for ground. There are 3 prongs on the other side of these wires.IMG_20220316_135846.jpg
 
Here is the wiring diagram. Looks like the Black/Yellow and Black both go to ground. Up to you what you do with it. :) Probably doesn't matter unless it matters. LOL


1996  GTX Mag Wiring.png
 
Thanks for the schematic! Now l see! There needs to be 3 prongs behind those 3 yellow wires. One is broken off. Is it easy to take that plug apart?
 
Pull the little orange thing in the middle and push the pins toward the middle.
 
Status
Not open for further replies.
Back
Top