seadoobie
New Member
I took a compresson test today and the results were.....engine 1: cyl. #1 @ 150psi,
cyl. #2 @ 240psi. engine 2: cyl. #1 @ 150psi, cyl. #2 @ 150psi.
Needless to say I'm worried about the cyl. pushing 240psi. I did spray all the cylinders with wd40 & spun them around a couple times before the test. From what I know about this boat is the engies were rebuilt 2 years ago, they were started & ran awhile with no problems, then it was weatherized & stored till recently. I'm probably looking at tearing this engine down & fixing the problem. But any ideas at this point would help! Thx!
cyl. #2 @ 240psi. engine 2: cyl. #1 @ 150psi, cyl. #2 @ 150psi.
Needless to say I'm worried about the cyl. pushing 240psi. I did spray all the cylinders with wd40 & spun them around a couple times before the test. From what I know about this boat is the engies were rebuilt 2 years ago, they were started & ran awhile with no problems, then it was weatherized & stored till recently. I'm probably looking at tearing this engine down & fixing the problem. But any ideas at this point would help! Thx!
