3d di U shaped exhaust hose

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

ThreeDee

New Member
Just wondering is there any reason that the exhaust hose shaped like a big U on the 3D DI cant be made shorter. .reason l ask is mine has become very thin in spots from heat and seadoo dont make them anymore . I was hoping to find out if l can make something up and if anyone else has done the same
 
Last edited by a moderator:
It's the only thing stopping water backing up inside the system, I would try and find a second hand one online or you might be able to make (or have one made) an alloy two 90° bends and then connect the rest with rubber hose joiners so you can fit it all in the hull and allows a bit of movement, just make sure the ends have a swage on the end as to ensure the hoses don't slide off
 
Status
Not open for further replies.
Back
Top