I just bought a 2013 gtr215 used from a boat dealer in another state. After driving a long way I got there and noticed there was recent damage that was not there before in the pictures they had on their site. The biggest issue being the plastic lens on the gauge cluster is shattered. Is there a way to get just this lens? I can't afford an entire new cluster after just buying this thing. I didn't realize it was that big of a deal when I bought it and the dealer may not do anything about it. Also, the vts doesn't move when I try it on the trailer. Does it have to be running in water or does that not work too? Kinda bummed
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
2013 seadoo gtr help
- Thread starter db13gtr
- Start date
- Status
Nike12000
Active Member
VTS won't move unless its running or you go into an override mode and then you can manually move the bucket.
Activating iBR Override Function
To activate the iBR override function, carry out the following step.
1. Power up the electrical system by pressing the START/STOP button.
2. Install the tether cord on the engine cut-off switch.
NOTE: The tether cord must be installed to ensure the information center will not shut off all indications after its self test function. Electrical power will stay on for approximately 3 minutes.
3. Press the Mode button on the RH handlebar repeatedly until SETTINGS is visible in the digital display of the information center.
MESSAGE DISPLAYED: "SETTINGS"
4. Press the SET button (RH handlebar) to display IBR OVR.
SPECIAL PROCEDURES
AVAILABLEMODE FUNCTION: "IBR-OVR MODE message"
5. Press the SET button to enter IBR OVR function and display OVR OFF.
MESSAGE DISPLAYED: "OVR OFF"
6. Press the UP/DOWN button (RH handlebar) to display OVR ON.
MESSAGE DISPLAYED: "OVR ON"
7. Press the SET button to select the OVR ON function. The gauge will return to its normal display.
8. Press the VTSUP/DOWN arrow button to move the iBR gate to the desired position.
Models Without a VTS UP/DOWN Button
NOTE: On models without the VTS UP/DOWN button, use the UP/DOWN button on the RH handlebar to move the iBR to the desired position once the iBR override function has been activated as described in the previous steps.
All Models
9. Remove the tether cord from the engine cut-off switch.
Activating iBR Override Function
To activate the iBR override function, carry out the following step.
1. Power up the electrical system by pressing the START/STOP button.
2. Install the tether cord on the engine cut-off switch.
NOTE: The tether cord must be installed to ensure the information center will not shut off all indications after its self test function. Electrical power will stay on for approximately 3 minutes.
3. Press the Mode button on the RH handlebar repeatedly until SETTINGS is visible in the digital display of the information center.
MESSAGE DISPLAYED: "SETTINGS"
4. Press the SET button (RH handlebar) to display IBR OVR.
SPECIAL PROCEDURES
AVAILABLEMODE FUNCTION: "IBR-OVR MODE message"
5. Press the SET button to enter IBR OVR function and display OVR OFF.
MESSAGE DISPLAYED: "OVR OFF"
6. Press the UP/DOWN button (RH handlebar) to display OVR ON.
MESSAGE DISPLAYED: "OVR ON"
7. Press the SET button to select the OVR ON function. The gauge will return to its normal display.
8. Press the VTSUP/DOWN arrow button to move the iBR gate to the desired position.
Models Without a VTS UP/DOWN Button
NOTE: On models without the VTS UP/DOWN button, use the UP/DOWN button on the RH handlebar to move the iBR to the desired position once the iBR override function has been activated as described in the previous steps.
All Models
9. Remove the tether cord from the engine cut-off switch.
- Status
Similar threads
