2004 seadoo rxp motor has water in it help

[Zackseadoo04rxp]

I have a 2004 seadoo rxp I let my buddy ride it and he flippped it. It was flipped for about 2-3 min now the motor has water in it. I’ve drained the oil multiple times I’ve pulled the plugs and blew the water out. I have to shake the ski and then blow the water out then shake it and the cylinders keep getting water in them how do I get it out??? Please help I’ve tried everything thank you!

 

[Chester]

The first thing you should've done is remove the intake manifold and get the water out of it. The water sits in the bottom of the manifold and will enter your engine everytime you start it.

Chester

 

[mkov608]

Wow! That sucks! I had that happen to my old '95 XP, but those 2-stroke engines are easy to take care of when they get flooded. I recommend you download your service manual and look in the section (Section 2 in my manual, Maintenance) for "water flooded engine."

2004 SeaDoo GTI, GTI LE, GTI RFI, GTI LE RFI, XP DI, GTX 4-TEC,RXP 4-TEC Shop Manual - FREE PDF Download!

The procedure is too long to post here. Whatever you do, get it done quickly.

 

[Zackseadoo04rxp]

Thank you guys I have just pulled the boots off the intake and there wasn’t much water do you think I have gotten most of the water out I have blew a lot out through the spark plug holes

 

[Chester]

Take the manifold off.

Chester

 

[mkov608]

Thank you guys I have just pulled the boots off the intake and there wasn’t much water do you think I have gotten most of the water out I have blew a lot out through the spark plug holes

It's not that simple. You need to read the procedure in the manual, or you can always rebuild the engine later.

 

[Zackseadoo04rxp]

Ok so I talked to the dealer that had went though my motor and put a brand new supercharger on the seadoo about 25 hours ago. He said what I need to do is to get all the water out. I have pulled manifold got all water ran it out of water with garden hose hooked up there is no water spraying out when I pull plugs and turn motor over my oil is a little milky so I’m going to drain the oil for about the 4th time. But my question is I took it and backed it in at the lake and let it run it ran fine so I decided to take it out and this is the problem it seems to run bogged down I guess you could say and puffs white smoke out the exhaust quite a bit of it. And there is a white ish paste on my exhaust. Any ideas would be appreciated and I’m pretty sure it’s not a blown head gasket. Thank you
Zack

 

[greenhornet2]

how long did you run it for like that? It could be burning out all the residual water but I would think it would clear out after maybe 10 minutes of running. Get the milky oil of it.

 

[Digdog]

Did you pressure test the intercooler ?