Hello everyone!!
I got my seadoo out yesterday to prep it for the upcoming season.
It fired up right away and I than put the hose to it and played with the throttle a bit to get all the fog out of it. I than for some reason shut the machine off while water was still running to it(stupid i know) i quickly started the doo back up but did not get any throttle response. I than shut the water off and than machine and waited for a few seconds. I fired the seadoo back up and than put the water to it and the throttle was fine and the machine sounded great. So after all this my question is.....is it possible flowing water to it for those couple seconds without the motor running could hae caused any damage????????
Like i said it ran fine afterwards.
any advise is greatly appreciated.
Thanks, and I hope everyone has a great season!
I got my seadoo out yesterday to prep it for the upcoming season.
It fired up right away and I than put the hose to it and played with the throttle a bit to get all the fog out of it. I than for some reason shut the machine off while water was still running to it(stupid i know) i quickly started the doo back up but did not get any throttle response. I than shut the water off and than machine and waited for a few seconds. I fired the seadoo back up and than put the water to it and the throttle was fine and the machine sounded great. So after all this my question is.....is it possible flowing water to it for those couple seconds without the motor running could hae caused any damage????????
Like i said it ran fine afterwards.
any advise is greatly appreciated.
Thanks, and I hope everyone has a great season!


