TurnerBFC
Active Member
Ok here we go again,
96 xp... completely rebuilt motor and carbs
-OEM Crankshaft
-CVTech Balance Shaft
-WSM Platinum 0.75mm over pistons.
-New fuel selector
-New 1/4" Fuel line all around
-New oil lines around
-Rave valves cleaned and set 3-clicks below flush at black cap
Compression is 153/152. Voltage is 13.6 volts with brand new OEM Rectifier.
Problem: Ski won't rev over 1/4 throttle in the water. Out of the water, I rev it and hold it full throttle... it will climb to full throttle and then begin to die down.
Help? ��
CAUSE OF PROBLEM FOUND: SEE POST #2,49,51
96 xp... completely rebuilt motor and carbs
-OEM Crankshaft
-CVTech Balance Shaft
-WSM Platinum 0.75mm over pistons.
-New fuel selector
-New 1/4" Fuel line all around
-New oil lines around
-Rave valves cleaned and set 3-clicks below flush at black cap
Compression is 153/152. Voltage is 13.6 volts with brand new OEM Rectifier.
Problem: Ski won't rev over 1/4 throttle in the water. Out of the water, I rev it and hold it full throttle... it will climb to full throttle and then begin to die down.
Help? ��
CAUSE OF PROBLEM FOUND: SEE POST #2,49,51
Last edited by a moderator: