After finishing my project of replacing fuel lines, cleaning carborator, and fuel tank, I took the GTX for a spin.
Day 1: It ran well, except if I went full throttle, it would always die as soon as I started to decelerate.
Day 2: Started out running well, but then it stopped accelerating. I could go maybe 15 mph, but then more throttle would cause the RPM's to rev way up, with no boat acceleration.
I was in shallow water when it first started doing this, so its possible sucked up some gunk, but not sure. This is the same behavior it had last season, which is why I cleaned the carb and replaced the fuel lines.
Any advice on what to look at first would be appreciated.
				
			Day 1: It ran well, except if I went full throttle, it would always die as soon as I started to decelerate.
Day 2: Started out running well, but then it stopped accelerating. I could go maybe 15 mph, but then more throttle would cause the RPM's to rev way up, with no boat acceleration.
I was in shallow water when it first started doing this, so its possible sucked up some gunk, but not sure. This is the same behavior it had last season, which is why I cleaned the carb and replaced the fuel lines.
Any advice on what to look at first would be appreciated.
	

