12V Low; Maint; Engine Stalls

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Not open for further replies.


New Member
Hi all
I recently purchased a 1998 Sea Doo GTX and put it in the water for the first time last weekend. It ran perfectly for about 15 or 20 minutes and then started to bog down and stall. The 12V Low warning light came on and so did the MAINT code.

Currently, the MAINT code comes on for a few seconds when i attach the ignition switch before it is replaced again by the 12V Low. The engine fires up and then stalls within a minute or so.

So far i have replaced the rectifier and made sure the battery is charged.

Any help would be greatly appreciated
Not open for further replies.