Bigbadjon
Member
Hi folks,
I read lots of posts but never post any, till now.
My 04 Speedster 200 310hp is acting up. Starboard engine starts but idles very rough. When I go to accelerate it emits a long beep and the oil light, goes into limp mode until I shut it down. I had it in the shop to repair this problem and they replaced a worn wear ring and a really bad one on the starboard pump. I thought that friction for the impellor could be causing my problems. Buds didn't have any warnings. Water tested today with new wear rings and still the same. If I let the starboard idle without any acceleration it would keep running (but rough). Until the temp light came on. Was able to get back on one engine. Sensor? Filter? Suggestions? Thanks. Jon
I read lots of posts but never post any, till now.
My 04 Speedster 200 310hp is acting up. Starboard engine starts but idles very rough. When I go to accelerate it emits a long beep and the oil light, goes into limp mode until I shut it down. I had it in the shop to repair this problem and they replaced a worn wear ring and a really bad one on the starboard pump. I thought that friction for the impellor could be causing my problems. Buds didn't have any warnings. Water tested today with new wear rings and still the same. If I let the starboard idle without any acceleration it would keep running (but rough). Until the temp light came on. Was able to get back on one engine. Sensor? Filter? Suggestions? Thanks. Jon
