03 gtx -A bit of a riddle

[kevinj]

I'm experiecing overheating problems with my machine. This occurs only when under repeated hard cornering or even slaloming. I can run machine hard as I want and long as want in a straight line and can even do this seconds after stopping to address the signal(ie. no further signals). Coolant levels are fine. There is moderate wear on the wear ring but nothing ridiculous (cavitation is manageable). Any thoughts or starting points would be appreciated.

 

[kustomkarl]

No riddle...check your cooling lines for a blockage.

 

[kevinj]

Visibly checked lines. No indications of a block. Should I disconnect at one of the junctures and try to blow them out.

 

[sporsterjoel]

whats over heating the motor or the exhaust????

 

[kevinj]

I'm thinking the exhaust which might explain the cornering.. not as much water being drawn in for the cooling to access