wiring

Hello, I purchased a 94 XP last year and starting work on it as of recently. Was told by the guy I purchased from that he heard a pop from the MPEM and I have not been able to find a 278-000-071 to replace it. I did some research and found that the 95 GTX has the same engine and I believe that a...

2008 Sea-Doo 180 Challenger So my original bilge pump went out. I am replacing it with a Rule pump with an automatic sensor built in. It now works perfect in auto but I cannot get the manual switch on the helm to work. Is this as simple as a bad switch possibly or is there something else that...

Hello - each time I ride my 2008 Sea-Doo GTI 130, after about an hour of riding I get injector short to ground codes (P0261, P0264, P0267). However, nothing happens to the skis performance. It doesn't sputter, cutoff, or misfire. I find it odd that it takes so much time for the codes to occur...

I have a 2012 Seadoo Speedster 150 HO. Here is a pic of a connector and I am trying to determine what sensor that it goes to. It is above the Deutsch connector for charging near the throttle body. The reason that I am trying to identify it is because I recently found the wire connected...

I recently disconnected my epem to check it with a voltmeter. I may have been a little over-zealous because I forgot to mark the wires or take pictures. I've looked all over the web and cannot find what I'm looking for. Does anyone have the wire diagram for it? Or pictures of theirs?

Took my speedster out and after 20 mins received a Code P0352 which is ignition coil #2.. changed the spark plugs and took it back out. worked for about 5 mins perfectly then code came back.. I then switch ignition coil #2 and #3 to see if i would get the code for Ignition coil #3(p0353) and it...

Hi Guys, I bought 3 second hand gauges for my 2003 Sportster LE 951 carb boat. The Speedo and Rev Counter wires matched perfect and work a treat however the Fuel gauge wires are different :mad: My original fuel gauge has 5 wires: 1 x black 1 x pink 1 x light purple 1 x light blue 1...

I am planning on putting a different momentary switch and hard wiring it to the wires that go to the stock switch. My question is ... Is there any critical circuitry in the OEM switch that I will be bypassing if I install a different one?

Hi, I picked up a Lowrance Elite 5 GPS/ Fishfinder unit with and external transducer and will attempt to install next weekend. Has anyone done this on a Seadoo Challenger 210? My boat is a 2012. So far, I have the Lowrance unit, a cool bracket I picked up from Tallon System that I will use...

Hey guys!!! I just got my '97 XP back after a family member was testing it out to buy it. He said he couldn't get it started so he went to tearing into it (it was running last time I rode it). Long story short... he discarded the coil that was most likely still good and I noticed a couple of...

ok here's my problem. Last year I nailed the face of a wake going about 50 and flipped my ski ripping the hood off. In doing that I completely screwed up my gauge wiring. From looking around on the web I found that the 99 gtxl gauge should work on my ski (according to some people). The part #...

I am in need of a start stop button for a 97 gts... I didn't know this part could just stop working but mine has and I am in need of one... please let me know if you have one that you would be willing to sell me or if you know where I could get one for let than Seadoo dealer wants for one...

I am being told by numerous sources, that the wiring harness I need is discontinued(part # 278001607). This is for a 2002 GTX 4Tec. CAN ANYONE HELP ME ON THIS? I looked for used online and there are only 2003 and 2004 available. Will they work? Why would they discontinue a part on an 8 year old...

hey everyone, i am swapping out my factory jbl radio for a new unit, does anyone have a wiring diagram or the color codes for the factory harness so i dont have to go tracing the wires back? it is a 2004 speedster 200 with the crappy black jbl radio face, i am looking for a wiring diagram or...