corrosion

Hello everybody, I was doing my bearing grease checking on my 2007 challenger 180 jet pump, and I removed reverse, venturi etc... I noticed lots of spot with starting corrosion even if anodes are still brand new and the boat only knows unsalted water...the heat exchanger plate is covered with...

I have a 04 GTI and the jet pump has had issues leaking. I pulled it to find it had weird chunks missing out of it. Would it be best to buy a whole new housing or is there somewhere that can replace just the sleeve? The seal damage is from me looking into it I planned on replacing the seal...

In my 1998 speedster the boat engine was not starting right, randomly shutting off, didn’t run right, stall at low rpm, had a vibration/rattling noise coming from back ,etc. I decided to do a full tuneup to see whats up (carbs, new filters, oil, head gaskets, peek inside to check pistons, plugs...

Got to the ramp the other day and pushed the ski off the trailer. Tried to start the motor it dragged then died. Then the solenoid started clicking. I replaced the solenoid and put in a new battery. The engine started up and sounded amazing. I turned it off then click click click in the...

Have a new Wake Pro 155, and keep it on a twin drive up dock in brackish water on the ICW, and have for the last 8 weeks or so. We also have a Yammy XVR that we keep on that dock. With brackish water, we are absolutely anal about our maintenance...flushing every day the skis are used. Yesterday...

I have a 2012 Challenger 210 SE 430. Its a great boat and we have used it a lot. It has been used in salt and fresh water but a decent amount in both, about 150 hours combined. I am having an issue with corrosion on the reverse gate and reverse support. There is also some corrosion on the bottom...