Is it possible you meant to type 275500111 the FUEL TUBE ADAPTER? Where the fuel pickup tube inserts into the fuel tank. Yes the part is discontinued but you may be able to find it used. The following link has a where used for the Fuel Tube Adapter.
275500111 Sea-Doo Adap - Tube Fuel - 2WheelPros
I can't seem to find any pictures on the internet that look like the PTO on my 96 XP. I'm wondering if the part is aftermarket? And if it is, should I replace it with a stock part since I'm biased towards reliability vs speed.
So I figured the carb was no good with the worn out throttle shaft, so I ended up taking it apart. It came apart ok. I needed to dremel down the back of the screws protruding from the back of the throttle shaft which hold the throttle plate. I had some difficulty getting the throttle plate...
Hello,
I've just finished rebuilding the carbs on my 95 spx. Upon assembly, I noticed that the PTO carb butterfly shaft flops around quite a bit. I'm pretty sure the bushings are shot on the butterfly on the linkage side.
Has anyone rebuilt the throttle shaft on the carbs before? I see the...
I was suspect of my brand new high quality Harbor Freight Compression tester (roll eyes). Holding the throttle open changed the reading from 85 to 90 psi. I used the loaner program from O'reilly and tried out two other testers. One didn't even work and the other one would kinda work if I held...
Hello,
I picked up a 95 SPX that has been sitting for about 3 years. I'm wondering about the compression. The engine has 90 psi in both cylinders.
I haven't been on the water with it but it starts fine on the trailer. The oil tank was dry and the hull had a bunch of oil in it. I've...