Recent content by gato760

Any luck?

Hello Seadoogirl72, I would move this thread to the "4-Tec Sea-Doo Boats" section of the forum and you might get more assistance. I have a 2006 C180 wake tower edition with the 215 hp engine. I usually hear two quick beeps when I put the lanyard on. A couple times I have gotten the one long...

When you got it back together, did you put any seals or o-rings where the seals are located in the photos I posted?

The manual calls it the Jet Pump Support. It is what the jet pump mounts to. I am not sure where I got the term pump housing from???

I am not sure where the pump came from because I bought this boat used last year. I did not see them in the manual, but since I had them I figured they are required. Are o-rings or seals supposed to be in the pump housing where those seals are in my boat?

I think I just found it online. The part number I got is 293250084. These seals are white, but I saw someone used ones pulled off and they had one whitish color seal and one pinkish color seal with the same part number. I just bought them both for about $18 with free shipping.

I just placed an order for the Solas 14/19 today. I am going to stick with what I know works in my boat. I am going to see what I can do about that grate!!

Yes sir. I cannot seem to find any replacements for them. Do you have regular o-rings in yours?

What's up C9R0J0! It has been a while since we last talked and I hope all is well with you my man. I had a Solas 14/19 when I bought the boat and it was really beat up along with the wear ring and the carbon ring. I replaced the Solas with another 14/19 impeller, SBT wear ring, and stock...

After all that carnage the boat cavitates when I try and throttle it. Its time to replace the the damaged wear ring and impeller.

Any recommendations?

No elevation, sea level at the Colorado River. Typically very warm water during boating season. In the upper 70's to mid 80's. Regards

Hi pvamax, My apologies for not stating some pretty relevant info - 2006 C180 Wake tower edition with a 215 hp 4tec. Regards

Hello, I am replacing my impeller again since I decided I would crush a bunch of rocks with a nearly brand new impeller and wear ring (see photo). This is thanks to the ICS and grate being down and locking open and it raked the ground and pulled everything up in over 2 feet of water. I can...

Hello my fellow boaters. I am trying to find the two "reddish" seals in the pump housing but not too successful (see photos): This is a 2006 C180 with 215 HP 4tec Any help would be greatly appreciated!! Regards