Recent content by fttf

95 Sea-Doo gtx where can I order a new one from

What is the troubleshooting no the speedometer and the multifunction gauge not working. I would like both too work but they don’t. I just didn’t want to spend money buying parts that not needed.

This is the o ring around the seat that will let gas seep in. Don’t know about the water and oil on top of pistons

Remove your carbs and check under the seat theirs a o ring see if there blown. The only way this could happen is the carburetors needle and seats not shutting off gas. Turn the fuel selector to off and turn motor over till all of the gas is off the top of pistons. Then check to see how it’s...

Leaking fuel from needle and seat. Probably has gas on top of pistons. Just screw out spark plugs and see if it will turn over.

The plastic 2 piece clamp was loose. I replaced the 2 nuts with new ones. Seems to have it fixed. Thanks guys

Where is the turnbuckle adjustment at?

How do I tighten the cable support bracket? You can hold the jet nozzle and have someone turn handlebars and the nozzle doesn't bind. Thanks

95 Sea-Doo gtx want turn right on the gas. Idling is turns fine. What causes this?

Spark plugs are fouling out in the no wake zone. Need carbs adjusted, and to fix the no right turns only left turns

I set the carbs on 1 1-4 out for low and 0 bottom out for high. Now in no wake zone I foul my plugs out, and another problem is the steering cable keeps coming out of the bracket under the steering wheel. Turns great left but no right turns. Is the steering cable messed up. How hard is it to put...

I replaced all grey lines, fuel selector was stopped up so I replaced it, cleaned carbs, and set low and high to seadoo specs. That fixed the problem with bogging. The spring on the oil pump return came unhooked. I fixed that and turned it counterclockwise till timing marks on pump lined up. So...

It fixed my problem. Clean the carbs, buy a new fuel selectior.

Yes cable in attached to the lever. The lever doesn't have tensions on it.