Recent content by chimeranzl

?? It's waterproof for water ingress anyway. It has a drain plug at the bottom you can pull out for any water that does get in there. It doesn't exactly need water proofing, unless you tip the ski. However the parts are secured in with black silicon and screws.

Put a sleeve inside the original hose?

Went with the push button idea, to turn voltmeter on and off. Don't make the mistake I did if you're gonna do this and drill through the top half of the glove box, too close to the steering cable and too much plastic support behind it! I 3D printed a seadoo badge and glued it in to cover up...

...worst case scenario, I'll just wire in a waterproof switch into the glove box too, to manually turn the voltmeter on or off. It's more of a convenience factor to be able to check battery voltage.

Looks exactly the same as the rear of my GTX 155 cluster, in which case top right pin is 12V + and bottom right pin is negative. That will provide power to the unit, but unsure if it'll light up - as you'd need to hook up the on/start button too it as well - unsure what pins these are.

I was in a very similar boat to you (no pun intended) came from 1998 2 stroke GSX Ltd 130HP, 2 seater, used that for a number of years until I came off several years ago nearly killing myself (literally) so sold it, got lazy and bought a massage chair for a while lol... but recently bought a...

Hey all, I'm doing a custom install of a waterproof USB charger and voltmeter unit in the glove box of my 2015 GTX 155 (has separate + and - wiring for each). I'm after a wiring diagram for the gauge cluster, so I can slice off and use some of those wires rather than running new wiring from...

thanks for the response. ok, I've found a '99 service manual so I'm hooking it up like this I'm assuming (which oddly, is the reverse of the image shown in the '98 service manual) - excuse the roughly drawn hoses in the pic, but these are the ones I'm confused on...

Hi, I've got a '98 GSX Limited which had leaking issues in the hull (through the pump shoe) so stripped it off re-siliconed it all and put back together. Problem is, it still leaks - actually worse :ack: Anyways I'm trying to find the source of the leak, but first up I've noticed the 2 small...