Search results

I'm trying to rebuild a pump and I installed the bearings using an arbor press and the shaft won't go in the second bearing. It's kinda tight going into the first one and just gets into the 2nd one and won't go any further? The shaft looks like it has line in it about 3/4 of an inch down from...

I just put the crank case halves together and the cover for the CB bearing rotates in the cases? I don’t remember this happing before but I might not have checked it before? Thanks

I need the water routing for the R&D pipe? Thanks

Set of 155 pump nozzles 87/90mm $150 + shipping I also have a 155 85mm exit nozzle

My xp that was rebuilt last year and has run fine for 20+ hours started to drop to idle after 30-60 seconds like a switch being flipped. I warmed it up for about five min rode it like normal for 2 min and it dropped to idle I thought it died the was it dropped. I pulled the key off and put it...

Hey all I’m look to buy a case of JT4 The true value used to be able to order it but not this year. Any ideas? Thanks

I was looking for some parts on EBay and came across New Mikuni 40i carbs for 97 spx for $143 from Hong Kong. These have to be knock offs right?

Will a 720 Factory pipe for an HX or XP fit in a 92 xp? What pipe is bigger the XP or HX? Thanks

Like it says can I use a 787Rfi head on an 787 carb engine?

I just put a top end on and it started the first few times and then no spark. The Batt was at 12.6 I charged it up to 13.3 starts right up every time . I drains it down to 12.6 and no spark. I have a new ground cable and a good pos cable the starter has new brushes and the solenoid is new...

I have an OEM 951 starter for sale. $150 shipped to the lower 48

The boat was running perfect I should have know it to seize. WOT for about 10 min just carving around a big open cove it cut off . I got it back to camp and the mag plug looked very light and the pto was black but dry. Last I check the plugs they look good a little dark 2 weeks ago. I’ve been...

The outside groove broke can it be fixed or saved?

Hey all one of my 96 xp’s is having trouble starting. I tried to start it today and the starter solenoid would buzz and not crank the starter. I checked the battery and it was good at 12.6 so I pull the plugs and it spins fine. I changed the solenoid out and I hit the button and it buzzes and...

It says for their for the HX? I don’t Facebook

I got my 96xp sorted with a new set of carbs and have about 20 Hr on the engine. I threw my old #5 curve MPEM in and dam! it made a noticeable increase on a stock boat I had forgotten how awesome it worked. I need to have my other 96xp’s MPEM reprogrammed .

WTB single gauge hood for an X4

I was just finishing up the break in and doing a plug chop on my 96xp with proks. 75 low and 145 highs. The plugs looked a little dark I turned the low and hi adjuster in a 1/4 turn each started it up and got a backfire. I thought it must of loaded up. Tried to restart it and it didn’t want to...

I’m having a runaway issue on my fresh rebuild. I pressure tested it before I installed it and it passed. I set the idle at 3000and it will stay the same but when I give it some gas it rev’s up and takes a few sec’s to go back. When I rev it a bit more the idle will only go back to 3500 Rev it...

I just started a new 800 build and the pto cylinder is much warmer almost hot compared to the mag cylinder after running for less than a minute. I have both low speed adjusters one turn out. Whtat’s going on?