Water Inlet Intake Spigot, Size?

[nsoley]

I have the famous Plastic Water Inlet Intake Spigot, that comes off the jet pump that protrudes into the hull. The Plastic OEM variant snapped flush with the jet pump assembly

The remnant plastic was still in the housing, so i took a heat gun and cleaned out the female threads as best as possible. I then drove an M12 bolt into the hole to clean up the threads as best as I could ahead of the new Aluminum Water Inlet Intake Spigot that is on its way.

Question is, does anyone know what is the thread size of the Water Inlet Intake Spigot? Yes, the M12 bolt fit, but I want to ensure that the incoming Aluminum Water Inlet Intake Spigot is an M12 Male thread as well. (Part Number 293700019) Let me know if anyone knows. Thanks!

Ordered this kit: Bailer / Water Tube Nipple Kit - Seadoo 580-951cc

 

[Poormanracing]

Not sure on the thread pitch but just put the bolt you used next to the new spigot and make sure the threads match up