thejuice48
Active Member
There are some older threads in how to remove / replace the VTS boot with the older hose clamps, but none for those with the plastic clamps already in place.
I need to replace the boot because it has never been done and the VTS motor was obviously damaged by water so I don't want that happening again.
How do I release these plastic clamps that are on there, and how does the boot fit over the end of the rod that sticks out. It doesn't appear from the outside anyway that anything is detachable or that it will fit through the small end of the boot.
I need to replace the boot because it has never been done and the VTS motor was obviously damaged by water so I don't want that happening again.
How do I release these plastic clamps that are on there, and how does the boot fit over the end of the rod that sticks out. It doesn't appear from the outside anyway that anything is detachable or that it will fit through the small end of the boot.