Hi guys new to the forum. Just looking for a bit of help. Have a 2012 rxp 260 that seems to be taking on water.
The ski was brought in November first outing the whole engine bay filled up with water so was returned to the dealer they looked at it and seemed to think it was an engine mount. Since then every outing I’ve had issues. Used it quite a lot and never really took on to much water but always a little bit more than it should. But the last couple of weeks it’s back to filing up probably id say about quarter full. This morning was only out for about 20 minutes and filled up returned in drained it out and went back out again only for it to fill back up again within about 15/20 minutes.
Not sure if it could be the seal or not. I left the bungs in when we got back out earlier so it was still full and wasn’t draining from anywhere.
Any advice would be greatly appreciated
The ski was brought in November first outing the whole engine bay filled up with water so was returned to the dealer they looked at it and seemed to think it was an engine mount. Since then every outing I’ve had issues. Used it quite a lot and never really took on to much water but always a little bit more than it should. But the last couple of weeks it’s back to filing up probably id say about quarter full. This morning was only out for about 20 minutes and filled up returned in drained it out and went back out again only for it to fill back up again within about 15/20 minutes.
Not sure if it could be the seal or not. I left the bungs in when we got back out earlier so it was still full and wasn’t draining from anywhere.
Any advice would be greatly appreciated
