Run wire for depth finder thru grommet with speed wire?

[glenn2726]

Hi all, am adding a Lowrance depth finder with water temp to my 97 Seadoo Challenger 1800. Just wondering if I cut the wire of the depth finder so I don't have to fish the connector to the depth finder thru hole if I could use the same grommet the speed gauge wire uses and run the wire in next to it. Is there room for both wires? If not what about putting a grommet thru the other jet plate in the same place? Anyone done this? If putting a new grommet in where would I get one and what is it called technically? Also what is used to seal the grommet on the inside of the hull? Thanks for your help looking to get this done next week when it is supposed to warm up..

 

[snikwad003]

Only 1 wire in the gromet or it will leak adding a gromet would be the best

 

[glenn2726]

Thanks, I was afraid of that. Guess I'll have to find a grommet for the other side in order to run wire for depth finder.

 

[snikwad003]

Try westside powersports @Minnetonka4me probably has what you need

 

[glenn2726]

Thanks, will get one ordered...