Removing the RES/OFF/FUEL cap

[CT3MP1]

im not sure exactly what it is called, but im currently changing my grey fuel lines and would like to take off the cap which holds the switch from res/off/fuel lines. anyone have ideas or have done this? i tried just a flat head and it lookd like i was just going to ruin the looks of it..

 

[ocod]

im not sure exactly what it is called, but im currently changing my grey fuel lines and would like to take off the cap which holds the switch from res/off/fuel lines. anyone have ideas or have done this? i tried just a flat head and it lookd like i was just going to ruin the looks of it..

Take off center cap of switch. Theres a phillips head holding it to selector.

http://fiche.seadoowarehouse.com/se...odelid=1997 Sea Doo PWC GTI FUEL SYSTEM (GTI)

 

[bigJake]

once you remove that screw, lift the switch off and there will be a large nut, remove that nut and the valve drops inside the hull

 

[CT3MP1]

ok i was looking for something like that and didnt look like i had a center cap, but i must be mistaken. thank you will try tomorrow.

 

[bigJake]

it is just a small rubber plug that covers the screw

 

[Jetskigoodies]

When you remove the small phillips head screw the knob might be hard to get off, just wiggle it gently in all directions. Remember its just plastic and you dont want to break the fins that actualy turn the selector

 

[Spimothy Leary]

also, if you want to dress up that cap... consider putting a billet one on... (the pic below shows it b4 i put the rubber cap back in)

I think i bought mine for $15 shipped, all my friends wanted one as well so I have bought 6 since then, got them from JSH.