Pulling 2 tubes/skiers behind a Sea Doo Challenger 180

[loonlake]

Does anyone know a way to easily attach 2 ski ropes for either tubes or skiers to the Ski Tow Hook on the back of a 2007 Sea Doo Challenger 180?

 

[jwheatley20]

Personally, Id buy a Monster Tower and be done with it. It makes towing so much easier. Ive pulled 4 hydro sliders on it. No tangles or knots. I know its not what you wanted to hear, but the small tow ring is a pain to work with. Especially when you put a thick tow rope for a tube in it. Ive pulled two tubers also with my tower, and it was so easy.

 

[loonlake]

I wanted a Monster Tower, but my garage door opening is not high enough for a tower. I only have a few inch clearance above my windshield. My garage ceiling is fine.

 

[CypherAZ]

Personally, Id buy a Monster Tower and be done with it. It makes towing so much easier. Ive pulled 4 hydro sliders on it. No tangles or knots. I know its not what you wanted to hear, but the small tow ring is a pain to work with. Especially when you put a thick tow rope for a tube in it. Ive pulled two tubers also with my tower, and it was so easy.

Almost every tower I looked into including Monster recommends you don't pull tubes from your tower. Just FYI.

 

[scooper77515]

Install a stainless pylon like I did, Had to make it by hand, and then hook second skier to the stock ring down on the swim platform.

Done.

And again, I can use this same picture...

 

[TJ198]

Scooper, can you post a picture of yours?

 

[scooper77515]

Yeah, here it is. Just a similar reproduction of the stock item but made out of a chunk of stainless stock. Much heavier, and much stronger. Yanks my butt out of the water no problem. Bottom is stock and top is the repro stainless one.

 

[Guruofsleep@aol.com]

pulling

Nice item scooper, is it OK if we steal your idea.